Waterproofing Services   Waterproofing Services
We can solve any seepage problems or basement leaks that your home may have. Guaranteed.
Visit these links for information about:
         Basement Waterproofing
click to view photo gallery      Openings such as cracks or other faults in basement walls can be an unwanted source of water infiltration. Depending on the type and extent of the problem, the repair can be localized or may require excavating around the entire building. When excavating around your entire house, our staff will take care not to disrupt more than is absolutely necessary to ensure that a quality repair is done. Although weather conditions can sometimes put things on hold, our experienced work force gets the job done quickly. Abalon applies the latest scientifically approved methods, under the supervision of trained personnel while using the best products and materials available. When the job is finished, water in your basement will be a thing of the past.
      Visit our photo gallery to see a step by step typical basement waterproofing repair.
         Weeping Tile
click for larger picture    Weeping tile is a perforated plastic pipe which is placed on the footing around the entire exterior perimeter of the house at the bottom of the foundation wall. In older homes this pipe might be made of clay or concrete material. The purpose of weeping tile is to collect excess water drainage down the exterior concrete wall. This prevents water pressure building up against the concrete wall and diverts the water before it is absorbed by soil causing the soil to swell.
click for larger picture      After the water enters the weeping tile it drains to the sewer at the catch basin or the sump pit in newer homes. Solid pipes are laid under the basement floor from the sewer or pit to each foundation wall and connected through the footing to the weeping tile. This system is unique to Winnipeg. A different weeping tile system is used in other cities.
 
Weeping tile is affected by foundation shifting, basement floor heaving, sewer backup and shrinking and swelling clay. Your Abalon representative will be able to advise you on any repair or maintenance required. See weeping tile photos.
         Sump Pits and Pumps
      Sump pits are plastic containers with approximately 20 gallon (90 liters) capacities which are placed in a convenient location in the basement with the top of the pit at floor level. In newer homes the pit is installed when the home is built. The weeping tile lines discharge into the pit and the water is pumped outside by a submersible pump near the bottom of the pit. The main purpose of the sump pit is to discharge weeping tile water outside instead of into the overloaded sewer system during heavy rains.
      Many homeowners with houses where the weeping tile system drains into the sewer have installed sump pits. This pit is connected under the floor to the catch basin. During heavy rains and flooding the sewer backup valve will close preventing weeping tile water from entering the sewer. This water is diverted to the pit and pumped outside. This only happens when the sewer backup valve is closed.
Typical Sump Pump Installation      The concrete basement floor is normally 4 inches thick. The floor is underlain by approximately 4 inches of pea gravel on top of the clay base. The gravel allows excess water to move freely laterally relieving pressure under the floor. Some contractors and home owners drill small holes in the top 4 inches of the sump pit to allow any water under the floor to seep into the pit. Caution must be exercised to ensure that these holes only drain the pea gravel. Do not drill holes more than 4 to 5 inches from the top of the pit. Some pits on the market have holes most of the way down the inside of the pit.
 
      These holes will allow the clay under the floor to dry out in dry years causing the soil to shrink. This can lead to telepost pads settling, clay under footings shrinking and creating hollow spots under floors. This can happen no matter how airtight the pit is. Your Abalon representative will be glad to explain your sump pit options to you.
go to top of page
         Back-up Valves
      A back-up (or backflow) valve is installed between the catch basin trap and the main sewer line to the house. There are many designs but the device is essentially a one-way flap that lets water flow out, but not back in. In the event of a sewer back-up, the valve closes to prevent the sewer water from entering the basement. Pop-up valves are usually installed along with back-up valves. These are located at the bottom of the catch basin. The principle is simple yet effective. Water rising in the pipe lifts a float that blocks the drain opening. Talk to your Abalon representative for options about preventing sewer water back-up in your home.
         Window Wells
      Window wells are installed where basement windows are below grade level. The purpose of the corrugated metal window well is to prevent the surrounding clay and top soil from filling the pit adjacent to the window. The metal window well does not stop any water from entering the pit and need not be attached to the foundation wall. The pit at the window is drained by several methods to the weeping tile at the bottom of the foundation. Good drainage is essential otherwise the pit will fill with water and leak into the basement in the area where the concrete wall and the metal or wood window join. Your Abalon representative will explain the different drainage systems and the costs and benefits of each.
         Chimney Leaks
click for chimney leak photos      On many older homes, the chimney structure (which is usually brick and concrete) attaches to the buildings basement. Over time there is deterioration in the mortar between the bricks below the ground surface that allows water to enter your basement. This water is usually noticed around the chimney clean out. (see photo) Let Abalon repair the damage and we'll ensure a water tight seal. See chimney leak photos.
         Seepage Problems
click for larger picture      Seepage is when water infiltrates into your basement through pourous concrete or tiny cracks in concrete and masonry walls and floors. This should be remedied as soon as possible to save your basement from deterioration and also prevent or minimize mould, fungus and mildew.
 
      Efflorescence can also be a problem. It is often mistaken as a type of mould. Efflorescence is a white crystalline (often powdery or fluffy) deposit in and on the surface of masonry materials like concrete, brick, clay tile, etc. This is a sign that moisture is below the floor or behind a wall. This water carries salts obtained from the soil and through capillary action infiltrates and in turn deteriorates the concrete or masonry. See efflorescence photo.
go to top of page
our motto... and it turned out nice again
Structural Repairs  Foundation Movement  Our Guarantee  FAQ
Retro Ads  Privacy Policy  About Our Company  Contact Us  Abalon Home
Abalon is an accredited member of the Manitoba Better Business Bureau Manitoba Better Business Bureau
Our Famous Lifetime Warranty